MODEL NO.: HTUS – 50
OPERATIONAL MANUAL
  1. Pull the strap from the coil & cut the strap as required length. Apply the strap around the package. Then insert one end of the strap into the seal in such a way so that flat surface of the seal remains facing outside the strap.
  2. Other end of the strap insert through the seal. Then hold the overlap portion of the straps with your left hand.
  3. Hold the tool by right hand. Insert bottom strap under the gripper of the tool. Pull the handle lock lever to grip the strap by the gripper.
  4. Adjust the windlass shaft in such a way so that the slot should be parallel with the base. Insert the top strap into the slot. 
  5. Move the tensioning handle up & down until the proper tension achieved.
  6. Seal the strap by using the recommended Sealer.
  7. Unlock the gripper by pressing down the tensioning handle.
SAFETY INSTRUCTIONS
  1. Before using the tool, read the operating instructions carefully.
  2. Wear hand gloves, safety shoe, Helmet, goggles during operation.
  3. Do not stand in line with the strap while it is tensioned. The strap may break.
  4. Do not put your fingers into the windlass shaft & gripper area.
  5. Do not put your hand under the strap on the job while strap is being tensioned.
  6. Only use equipment recommended for the strap.`HTUS-50´ is recommended only for 1.10 mm to 1.27 mm thk. X 31.75 mm width.
 
PNEUMATIC POWER TOOLS & CO.
India Office:
68B, A.P.C. Road, 2nd Floor, A. K. Point, Kolkata – 700 009, India
Ph. No.: +91-33-2352 2813, +91-33-2443 6211 | Mobile: +91-9830869960, +91-9830647905 | Fax No: +91-33-3508892 | Email: info@strappingtoolppt.com

North America Office:
35 Bruce Drive, Shelton, CT 06484
Phone: +208-305-2281 | E-Mail – aveek.datta@romipackaging.com / lina.datta@romipackaging.com
(Contact Romi Packaging www.romipackaging.com for sales inquiry in North America, Mexico and LATAM)

Dubai Office:
Seema Ajit, 324,Sultan Business Center, DUBAI, U.A.E.
Phone - 0097142286318, 00971506510896, 00971505591389 | Email: ajitdxb@eim.ae