This pneumatic tensioner is generally designed for heavy-duty industrial applications. The product works great for flat and round necks. The product features a fast roller opening and fast strap tensioning when used in conjunction with a pneumatic sealer.
Pneumatic Tensioner can provide you with a strap thickness of about “0.89mm/0.035mm” with a width of 19.05 – 31.75 mm/3⁄4″ – 11⁄4”. It needs air pressure of about 5.5 – 6.0 Kg/cm2 for efficient operation. It can achieve a high tension level that goes up to 725 Kg/1600lb at 6 Kg/cm2 (84 psi). To get more details about the pneumatic tensioner, you can contact Romi Packaging. You can also purchase this product from our website securely.
FEATURES
- Pneumatic Pusher type Steel Strap Tensioner
- For use where availability of air pressure is low (4.0-4.5 kg/cm2)
- Easy to operate and maintain
- Suitable for use on Flat, Round, Irregular & Narrow Surface
SPECIFICATIONS
Strap Thickness: Up to 0.89 mm/0.035”
Strap width: 19.05 – 31.75 mm/3⁄4″ – 11/4”
Grade: Regular Duty / High Tensile.
Tension Achievable: 4.5 kg/cm2 – 725 kg/1600lb
6 kg/cm2 – 860 kg/1900lb
Air Pressure: 4.0 – 4.5 kg./cm2.
Weight: 4.550 kg / 10 lb
Dimension (L X W X H): 303 x 116 x120 mm / 11.9”x 4.5”x 4.2”
OPERATIONAL MANUAL
- Pull the strap from the coil & insert the strap in to the seal in such a way so that flat surface of the seal remains facing outside the strap.
- Apply the strap around the package and bottom strap insert through the seal. Then hold the overlap portion of the straps with your left hand.
- Bend the extended strap as Hook against the seal.
- Pull out excess slack with your right hand.
- Hold together the handle and body of the air motor with your right hand and lift upward the air motor portion against the handle to make gap between feed wheel & lower Roller.
- Insert the top strap under the strap guide & feed wheel of the tool, at the same time push the tool forward against the Seal, and release by the air motor body.
- Turn the Control ring clockwise for tensioning until the proper tension achieved & switch off the motor by turning the control ring anti -clockwise.
- Seal the strap by using the recommended Sealer.
- Swing the tool up & down until the strap is cut off.
SAFETY INSTRUCTIONS
- Before using the tool, read the operating instructions carefully.
- Wear hand gloves, safety shoe, Helmet, goggles during operation.
- When cutting the strap hold the upper portion and stand safely away from the strap.
- Do not stand in line with the strap while it is tensioned. The strap may break.
- Do not put your fingers into the Tensioner wheel area.
- Do not put your hand under the strap on the job while strap is tensioned.
- Only use equipment recommended for the strap.`T177R’ are recommended only for 0.64 mm to 0.89 mm thk. X 19.05mm and 31.75mm width.
0 Reviews
There are no reviews yet.